Nylon ribbon mold is a good helper for making molds. There are many temperature requirements for this kind of mold equipment, which are introduced one by one below.

1. Nylon ties are hygroscopic. Do not open the package before use. After opening the package in a humid environment, try to use it up within 12 hours, or repack the unused nylon ties, so as not to affect the tensile strength and rigidity of the nylon ties during operation and use.

2. During operation and use, the tension shall not exceed the tensile strength (tension) of the nylon tie.

3. The ring diameter of the bound object shall be smaller than that of the nylon binding belt, and the remaining length of the belt body after tightening shall be 80mm. Nylon ties can maintain excellent mechanical properties and thermal aging resistance in a wide temperature range (- 40 ~ 120 ℃). The influence of humidity on nylon ties. Nylon ties are in a humid environment,

It can maintain excellent mechanical properties. Nylon ties have hygroscopicity, increased humidity (water content), higher elongation and impact strength, but the tensile strength and rigidity gradually decrease. Electrical characteristics and flame retardant nylon ties have good insulation, and the electrical rated temperature is less than 105 degrees

The flame retardancy reaches 94v-2 determined by UL. The plastic industry is worthy of vigorous development, and the prospect is very optimistic. It is understood that the high growth trend of the plastic industry is not reduced, and it is still in a period of high-speed development. Electronic communications, automobiles, building materials, office equipment, daily necessities, etc. are still in use

It is the driving force for the rapid development of plastics. It is expected that the average annual consumption of plastics will increase by 18%. The plastic industry is a sunrise industry worthy of vigorous development and an industry with promising market prospects. Therefore, it is necessary to establish an e-commerce platform with access system to standardize market product quality,

Then drive the upgrading and transformation of the whole plastic industry. Access is the standard and the threshold for entering the market. It is to combine the direct and indirect experience of plastic processing enterprises to establish their own standard system and form a technical support platform for plastic product upgrading.