Nylon ribbon mold is a good helper for making molds. There are many temperature requirements for this kind of mold equipment, which are introduced one by one below.

1. Nylon ties are hygroscopic. Do not open the package before use. After opening the package in a humid environment, try to use it up within 12 hours, or repack the unused nylon ties, so as not to affect the tensile strength and rigidity of the nylon ties during operation and use.

2 operation

When in use, the tension shall not exceed the tensile strength (tension) of the nylon tie itself. 3. The ring diameter of the bound object shall be smaller than that of the nylon binding belt, and the remaining length of the belt body after tightening shall be 80mm. Nylon ties can maintain excellent mechanical properties in a wide temperature range (- 40 ~ 120 ℃)

Characteristics and heat aging resistance humidity has an impact on nylon ties. Nylon ties can maintain excellent mechanical properties in a humid environment. Nylon ties have hygroscopicity, increased humidity (water content), higher elongation and impact strength, but the tensile strength and rigidity gradually decrease.

Electrical characteristics and flame retardant nylon ties have good insulation. The electrical rated temperature is less than 105 ℃, which does not affect its performance. The flame retardant reaches 94v-2 determined by UL. The plastic industry is worthy of vigorous development, and the prospect is very optimistic. It is understood that the high growth trend of the plastic industry remains unabated, and it is still in a bad situation

In a period of rapid development. Electronic communications, automobiles, building materials, office equipment and daily necessities are still the driving forces driving the rapid development of plastics. It is expected that the average annual consumption of plastics will increase by 18%. The plastic industry is a sunrise industry worthy of vigorous development and a market prospect

Good industry. Therefore, it is necessary to establish an e-commerce platform with access system to standardize the market product quality, so as to drive the upgrading and transformation of the whole plastic industry. Access is the standard and the threshold for entering the market. It is to combine the direct and indirect experience of plastic processing enterprises,

Establish its own standard system and form a technical support platform for plastic product upgrading.