Many molds are affected by temperature, and nylon tie molds are no exception. Nylon ribbon mold is a good helper for making molds. There are many temperature requirements for this kind of mold equipment, which are introduced one by one below.

1. Nylon ties are hygroscopic. Do not open the package before use. After opening the package in a humid environment, try to use it up within 12 hours, or repack the unused nylon ties, so as not to affect the tensile strength and rigidity of the nylon ties during operation and use. 2 operation

When in use, the tension shall not exceed the tensile strength (tension) of the nylon tie itself. 3. The ring diameter of the bound object shall be smaller than that of the nylon binding belt, and the remaining length of the belt body after tightening shall be 80mm. Nylon ties can maintain excellent mechanical properties in a wide temperature range (- 40 ~ 120 ℃)

Characteristics and thermal aging resistance

The influence of humidity on nylon ties. Nylon ties can maintain excellent mechanical properties in a humid environment. Nylon ties have hygroscopicity, increased humidity (water content), higher elongation and impact strength, but the tensile strength and rigidity gradually decrease. Electrical characteristics and flame retardancy

Long tie has good edge resistance, the electrical rated temperature is less than 105 ℃, which does not affect its performance, and the flame retardancy reaches 94v-2 determined by UL. The plastic industry is worthy of vigorous development, and the prospect is very optimistic. It is understood that the high growth trend of the plastic industry is not reduced, and it is still in a period of high-speed development. And electricity

Sub communications, automobiles, building materials, office equipment and daily necessities are still the driving forces driving the rapid development of plastics. It is expected that the average annual consumption of plastics will increase by 18%. The plastic industry is a sunrise industry worthy of vigorous development and an industry with promising market prospects. Therefore, it is necessary to build

Establish an e-commerce platform with access system to standardize market product quality, so as to drive the upgrading and transformation of the whole plastic industry. Access is the standard and the threshold for entering the market. It is necessary to combine the direct and indirect experience of plastic processing enterprises to establish their own standard system and form

Become a technical support platform for plastic product upgrading.